舊電纜橋架修復與維護
隨著時代的發展，電子工業是在電子科學技術發展和應用的基礎上發展起來的。電子工業是國民經濟支柱產業之一，也是新興科學技術發展產業。電纜的防護就會顯得尤其重要，使用電纜橋架可以起到電纜防塵防腐等傷害電纜使用壽命的情況出現。
With the development of the times, the electronic industry has developed on the basis of the development and application of Electronic Science and technology. Electronic industry is one of the pillar industries of the national economy, and it is also an emerging science and technology development industry. The protection of cables will be particularly important. The use of cable tray can play a role in cable dust prevention, corrosion prevention and other damage to the service life of cables.
下面為大家整理了如何修復和保護電纜橋架，使其延長使用壽命同時降低維修的費用。
The following is how to repair and protect the cable tray to prolong its service life and reduce the maintenance cost.
電纜橋架防腐
Corrosion prevention of cable tray
一、銹跡處理
1. Rust treatment
通常電纜橋架采用氯磺化底漆二道進行兩部分除銹，表面除銹處理質量直接影響防腐工程的壽命，現場除銹通常是砂輪機或者人工除銹，在表面處理之后，在4小時內涂上底漆。如果處理不當發現有新銹進行重新處理。
Generally, the cable tray adopts two coats of chlorosulfonated primer for two-part derusting. The quality of surface derusting treatment directly affects the service life of the anti-corrosion project. The on-site derusting is usually done by grinder or manual derusting, and the primer is applied within 4 hours after the surface treatment. If new rust is found after improper treatment, it shall be treated again.
2.涂層處理
2. Coating treatment
涂層工藝分為刷涂、滾涂。刷涂或者滾涂時每層應縱橫交錯反復進行涂，直到均勻為止，不能出現漏涂。
The coating process is divided into brush coating and roller coating. When brushing or rolling, each layer shall be applied repeatedly in a crisscross manner until it is uniform, and there shall be no holiday.
3.施工環境要求
3. Construction environment requirements
環境需要通風良好，溫度在13℃-30℃，不得低于5℃，相對濕度保持在80%以內。不宜在強烈日光下施工。遇到雨、霧、強風氣候不得在室外進行施工。
The environment needs good ventilation, the temperature is 13 ℃ -30 ℃, not less than 5 ℃, and the relative humidity is kept within 80%. It is not suitable to construct under strong sunlight. In case of rain, fog and strong wind, construction shall not be carried out outdoors.
1.避免擺放在高溫潮濕地方。
1. Avoid placing in hot and humid places.
2.避免與腐蝕性液體接觸。
2. Avoid contact with corrosive liquids.
3.可用電纜橋架專用的保養蠟進行保養。
3. The special maintenance wax for cable tray can be used for maintenance.
4.定期清理電纜橋架表面的灰塵與銹跡。
4. Regularly clean the dust and rust on the surface of cable tray.
以上就是為大家介紹的有關山東電纜橋架的詳細的介紹,希望對您有所幫助.如果您有什么疑問的話,歡迎聯系我們.我們將以的態度,為您提供服務http://www.njjfsc.com
The above is a detailed introduction about Shandong cable tray, which I hope will be helpful to you If you have any questions, please contact us We will provide you with professional service http://www.njjfsc.com
